Quote:
Originally Posted by waterpolo820
Alright finally!! A DYI for replacement gauge lights!!!
STCIKY PLEASE!!
going to try this out over the next weekend, thanks 97_RLer!!
BTW: Blue looks pretty sick, but I think I'll be going for red myself.
|
Thank you for your compliment!
Quote:
Originally Posted by SJSU95132
Dear 97_RLer;
Thanks for your information~
I do follow your information and purchased these LED bulbs.
As you can see, the red line of engine RPM and the water temp were gone, so, it seems I better to use white LED bulbs? or original traditional bulbs?
Also, I used the "3rd"set of screws( must be the screws for gas level cluster) on speed cluster., but, I found this error few seconds later and correct this error, however, unfortunately, my speed cluster is done now! 
I'm not sure if I install screws too tight? or I really crashed speed cluster.
Anyhow, I really like this 04" style ~~ many many thanks~
 |
Thanks man! Do you really care about the tiny red lines? Just forget it and enjoy~~~~~~~~ Anyway, The white LED can illuminate all area as I mentioned before.
As for your speedometer, the screws are not just screws but they are electrodes as well. You have to use the original screws or at least the same length, diameter, and thread to replace. Otherwise, the speedometer will not work. Just in case, you can't use teflon tape wrapping the screw to make tight on board since the teflon tape block the current flow through the screw causing non-fuctioning gauges.