DIY: Programming Your Factory Alarm Remote

[C25A1guy]

Storing transmitter codes:
The codes of up to three transmitters can be read into the keyless receiver unit memory. (If a fourth code is stored, the code which was input first will be erased.)

NOTE: It is important to maintain the time limits between the steps. Make sure the doors and the hatch are closed.

1. Turn the ignition switch ON (II).

2. Within 1 to 4 sec., push the transmitter lock or unlock button with the transmitter aimed at the receiver under the audio unit.

3. Within 1 to 4 sec., turn the ignition switch OFF.

4. Within 1 to 4 sec., turn the ignition switch ON (II).

5. Within 1 to 4 sec., push the transmitter lock or unlock button with the transmitter aimed at the receiver under the audio unit.

6. Within 1 to 4 sec., turn the ignition switch OFF.

7. Within 1 to 4 sec., turn the ignition switch ON (II).

8. Within 1 to 4 sec., push the transmitter lock or unlock button with the transmitter aimed at the receiver under the audio unit.

9. Within 1 to 4 sec., turn the ignition switch OFF.

10. Within 1 to 4 sec., turn the ignition switch ON (II).

11. Within 1 to 4 sec., push the transmitter lock or unlock button with the transmitter aimed at the receiver under the audio unit.

12. YOU SHOULD NOW HAVE HEARD THE SOUND OF THE DOOR LOCK ACTUATORS! Within 1 to 4 sec., push the transmitter lock or unlock button again.

13. Within 10 sec., aim any remaining transmitters (up to two additional ones) whose codes you want to store at the receiver, and press the transmitter lock or unlock buttons. Confirm that you can hear the sound of the door lock actuators after each transmitter code is stored.

14. Turn the ignition switch OFF, and pull out the key.

15. Confirm proper operation of the transmitters.

The instructions seem a bit repetitive but they will properly program your keyless transmitter.

[R's SX-S]

Is there a way to program your keyless entry to roll down windows auto matically by holding the unlock button? If so I'd really appreciate your instructions on how to do this.
Thanks

[jinny]

if the RSX is anything like my acura, no... not easily like that... I think you will need some new hardware wired in there to get that function.

[C25A1guy]

Can somebody else try this with their cars? I just want to see if it works for other applications.

[I-R-OWNED]

It works with other cars, but using slight variations in the amount of times you turn the key.