Acura World banner
1 - 1 of 1 Posts

1 Posts
Discussion Starter · #1 ·
I just put a new clutch into my Acura. Everything went fine until I buttoned it back up and when to test it. I can get it into 1st and 2nd no problem, but anything higher than that is like I am trying to shift without using a clutch.

Things I have checked and double checked:
Fluid in the Clutch Cylinder topped off (Bleed)
Transmission fluid refilled
Slave Cylinder replaced
Linkage connected properly and shifting when the car is off
Flywheel was smooth, not too worn
Transmission went back into place without issues.

Has anyone ever ran into this problem? Any ideas on how I can diagnose this without removing the transmission again unless I have to? If that is what needs to be done, what could I have done wrong?

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.