Acura World banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hey guys so I’m supercharging my tsx with a 3rd gen m90 supercharger and I was wondering what cam would be the best for my set up. This is everything I plan to do to the motor.

k24A2:skunk to alpha valves, skunk 2 alpha valve springs with titanium retainers, super tech valve stem seals, 1000cc injectors and a k20a2 ported oil pump.

I plan to rev to 10k RPM. I just need a good cam upgrade and don’t know what cam would be best for my set up. Any help would be awesome! Thanks guys.
 

·
Registered
Joined
·
125 Posts
You will need more than what you stated. A reliable tune, since your not lowering compression. Secondly not sure the bottom end will handle that kind of rpm. You probably should build the bottom end and use good light weight rods and pistons along with a crank balance! If ypu out pistons you can lower the compression with the pistons.
Everything you described not being enough, think you might be in for a catastrophic event.
 
1 - 2 of 2 Posts
Top