Acura World banner
1 - 11 of 11 Posts

·
I am no one
Joined
·
14,751 Posts
exactly, rear and sides are all good, but the fornt needs tons of work. not only the mounting points, the 02 front lip doesn't even fit in the 99-01
 

·
Bling_Bling INSPIRE 32V
Joined
·
3,018 Posts
fahoumh said:
front needs professional modification.
Professtional modification?? :rolleyes:

some bondo!! :D
 

·
Bling_Bling INSPIRE 32V
Joined
·
3,018 Posts
rominl said:


actually it does. i believe the front lip has to be cut up into pieces in order to fit
Question regarding bondo?? Of course bondo's required!!! ;)
But it didn't have to cut up into pieces though.

Here is a pic for CL member who put TL-S bodykit on his CL.


**edited** ;)
 

Attachments

·
I am no one
Joined
·
14,751 Posts
umm.... you sure? i remember reading the whole thread by the guy with that cl on other other forum, and he said for the front lip, the 02 tl front lip is not wide enough for the cl, so the shop had to cut the lip into three pieces, put them on, and fill up the gap. then the side of the front lip is too long and they had to cut off some.

for the side skirt the tl one is definitely too long and the shop had to cut it up as well. and for the rear again the lip is not as wide.

everything is from my memory so i could be wrong. :)
 

·
Bling_Bling INSPIRE 32V
Joined
·
3,018 Posts
rominl said:
umm.... you sure? i remember reading the whole thread by the guy with that cl on other other forum, and he said for the front lip, the 02 tl front lip is not wide enough for the cl, so the shop had to cut the lip into three pieces, put them on, and fill up the gap. then the side of the front lip is too long and they had to cut off some.
Hey rominl,

I guess you're right about that!! I had to go back and check it out one more time. Good memory!! :D
But by just looking at the pic, there isn't any signs that the front lip was cut in 3 pieces. :(

CL member said:
Front Spoiler: Too short, does not wrap around CL bumper, need to cut in 3 pieces, fabricate extensions, lots of new mounting points, cut alot of certain critical points to allow to force spoiler to shape to CL bumper. The hardest part.
 

·
I am no one
Joined
·
14,751 Posts
songoku said:


Hey rominl,

I guess you're right about that!! I had to go back and check it out one more time. Good memory!! :D
But by just looking at the pic, there isn't any signs that the front lip was cut in 3 pieces. :(

hehe, it's cool man. i remember coz' i was soooo amazed at the result of the work (and also the amount of the work needed) :)
 
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top