Acura World banner
1 - 1 of 1 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter · #1 ·
Automotive exterior Bumper Auto part Rim Vehicle


-When you get the lens out turn it on the side and look for this ballast. Turn the ballast counter clockwise to release the prongs and pull the bulb out.
Auto part Technology Carburetor Automotive engine part Sewing machine

Auto part Carburetor Automotive engine part Engine


-Pull the old bulb out and replace with the LED. *Most LED's only work when plugged in one way, they are polarized... so test the bulb BEFORE you button everything back up* If it doesnt lite then remove the bulb, rotate, then plug it back in.
Technology Auto part


-Install the LED bulb into the ballast rotate the ballast clockwise to lock it back in place and then line the two prongs on the back of the lens with the two holes in the body and push towards the front of the car until you feel it snap in place... replace the 2 screws (do not over tighten) and screw covers.
:boink:
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top