Acura World banner
1 - 10 of 10 Posts

·
Registered User
Joined
·
92 Posts
Discussion Starter · #1 ·

·
NO AMG, NO CARE
Joined
·
10,481 Posts
links dont work?
 

·
Can you hear me now
Joined
·
593 Posts
Looking good
love the silver color:) :) :)
 

·
Bling_Bling INSPIRE 32V
Joined
·
3,018 Posts
Looks good Rich.

Gotta love Silver!! :D
 

·
I am no one
Joined
·
14,751 Posts
TLontheDL said:
you installed it yourself?? wow, looks professionally done! :) good job! let me ask you something, how do you install your side skirts?? do you have to turn your front wheels to the side and slide out the stock side skirts???
haha, no, installing the kits is really easy and i am sure everyone here can do it. for the side skirts, basically you just get under the car, loosen the screws (3 of them if i remember right?), then also the scrws inside the front wheel well (2 of them?).

now the hard part. you have to push the whole side skirt forward (towards the front of the car) to make it loose. it's hard, and what i did (probably what most people did too) was to use a strong metal tube and use the rear wheel as the lever point to push the skirt forward.

one it slides forward the kit will fall off. take out all the white clips inside and put them in your new skirt. after that just pop the kit in place and you are done
 

·
Bling_Bling INSPIRE 32V
Joined
·
3,018 Posts
rominl said:
now the hard part. you have to push the whole side skirt forward (towards the front of the car) to make it loose. it's hard, and what i did (probably what most people did too) was to use a strong metal tube and use the rear wheel as the lever point to push the skirt forward.
I've used rubber hammer to slide it forward. Little bit of impact!! :D
 

·
Registered User
Joined
·
92 Posts
Discussion Starter · #8 ·
TLontheDL said:
you installed it yourself?? wow, looks professionally done! :) good job! let me ask you something, how do you install your side skirts?? do you have to turn your front wheels to the side and slide out the stock side skirts???
Well that's how you're suppose to do it! :)

When I removed them I really wasn't sure how they were suppose to come out so I kinda just pulled the skirt off, clips and all. Luckily I didn't break any of the clips. :D

When I installed the new side skirt, I just put the clips on the skirt and aligned it with the holes and smacked it into place. It's nice and secure!!
 

·
I am no one
Joined
·
14,751 Posts
rmarin2 said:

When I removed them I really wasn't sure how they were suppose to come out so I kinda just pulled the skirt off, clips and all. Luckily I didn't break any of the clips. :D
what the heck? now that's a great idea ;)
 
1 - 10 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top