Radar Hardwire and Shock Sensor install a GO!
The shock sensor install was harder than expected. I tried wiring the power to the orange trunk wire but was difficult since the splicers I bought were meant to be used on thicker guage wire. Either way, I ended up using the normal power in the back of the fuse box like everyone else...but the sensitivity of it is NOT good enough! I mounted the shock sensor to the ignition cables but even though I shake the car, the sensors still dont trip. I know 100% they work because I can be inside and tap the sensor and it'll trigger the alarm. Where else have you mounted the shock sensor so that even a cat can set it off?
1 - 1 of 1 Posts
1 - 1 of 1 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Acura World
A forum community dedicated to Honda Acura owners and enthusiasts. Come join the discussion about performance, modifications, classifieds, troubleshooting, maintenance, and more! Open to all models including the Integra, RSX, RDX, and MDX
Full Forum Listing
Recommended Communities
