Acura World banner
1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Just got a 4th generation TL 2010 and wanted to add spacers, but not sure what size to get. Any responses would be helpfull, I do not want the wheels sticking out to much but just right. Thanks
 

·
Registered
Joined
·
1 Posts
You can use a ruler to measure the distance between the wheel and the sub-board to determine how thick it is to fit it.

Recently I was considering installing wheel spacers on my car, I saw the BONOSS forged active cooling wheel spacers (formerly bloxsport) on the Internet, and some youtubers shared and installed these component. So I install that last week.

They have aluminum alloy 7075-T6 and 6061-T6 options. 7075-T6 will be more expensive but better in quality. In fact, 6065-T6 is good enough. Its tensile strength, yield strength and elongation can support our normal use. And its lugs are grade T10, studs are forged grade 12.9.

If you need it in the future, this is their case article.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top