Acura World banner
1 - 1 of 1 Posts

· Registered
3 Posts
Discussion Starter · #1 ·
So I bought a 2002 Acura RL that needed a transmission back in December and could never get the extension shaft out so I could drop the transmission. I stopped working on it due to weather and frustration. I got the engine and transmission pulled out last week and the transmission is now sitting on a work bench. I still cannot get the extension shaft to move in or out. It will turn (and grind) by hand. I've been whacking it with a rubber mallet trying to get the tip out of the 36mm hole to remove the set ring so I can pull it out the bell housing. It's just not moving. Am I missing something? Does it need to be in a certain gear or anything? Any help will be appreciated. Thanks.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.